Vacuglide Accessories

VacuGlide comes with a set of 3 sizes of silicone sleeves but some men may wish to further dial in their pleasure experience to the max. For those men, we offer these latex rubber sleeves which are noticeably thinner than the stock silicone sleeves and are offered in multiple sizes. Each sleeve comes in a single 30-32 inch long section which you must cut to fit into your stroking cylinder of choice. You should be able to cut at least 4 usable sections from one of these long tubes of latex rubber.

3 silicone sleeves only

3 cups, the valve cap, the 3 sleeves, the hose, and the tool

Vacuglide US Adaptor

Your VacuGlide's cap requires one of these silicone valves to operate. It is simple to remove by placing a flat head screwdriver underneath it, and gently pressing it up and out. CLICK HERE to watch a video of the valve replacement and removal procedure. If you grip this with pliers or otherwise try to remove it without lifting it by the edge by gentle prying, you will rip it and it will need to be replaced. Two valves are included in each set so you will always have an extra if needed.

This cap enables the suction function on all of your VacuGlide tubes. It comes off by hard pulling and snaps into place. It is swappable to any of the different stroker tube sizes. The silicone nipple is permanently affixed to the top of this cap and it additionally comes with 1 grey silicone insert which helps regulate the pressure.